Measurement of Power:

Analog Electronics Process Controllers : An Analog Electronics Process Controllers must be capable of providing one or more of the three main methods of control, namely, Proportional, Integral and Derivative. The circuits described in this section use high gain OPAMP’S with specially designed …


Basic Automatic Control : Multivariable systems are used more commonly in this age of Basic Automatic Control. Control parameters are becoming more complex by the day and the range of applications wider. In such complex systems, there are more than one input …


Bolometer : Bolometric measurements are based on the dissipation of RF power in a small temperature sensitive resistive element, called a Bolometer. This bolometer may be a short ultra thin wire having a positive temperature coefficient (PTC) of resistance, called Baretter, or …


Define Offset Error : Define Offset Error – Proportional control action is characterized by a permanent residual error in the operating point of the controlled variable when a change in load occurs. This error is called the OFFSET. The offset can be reduced …


Heat Capacity of Calorimeter : Heat Capacity of Calorimeter – RF power may be directly converted into heat. Water acts as the load, and RF power may be used to heat an element such as a long transmission line, water being used …


Measurement of Power Transmission Lines : When power is applied to Measurement of Power Transmission Lines, the source to load impedance must be matched in its characteristics impedance (Z0). The impedance all along the line is equal to the characteristic impedance. Therefore, …


On Off Controller : The On Off Controller or two position controller is the simplest, cheapest and the most used controllers. It is used in domestic heating systems, refrigeration, water tanks, etc. When the measured variable is below …


Proportional Controller : In many processes, the cycling that occurs with the two position ON—OFF control is undesirable. Steady process controlled in the absence of noises, is possible when the controlled variable is a continuous function of the error. A most widely …


Standing Wave Ratio Measurements : Standing wave are created along the length of a transmission line due to the mismatch between the characteristic impedance Z0 and the terminating impedance of the transmission line. The actual voltage E on the line at any point …


Step Function Response : The step function response consists of applying an instantaneous change in the control means and then recording graphically the result of the change on the measured variable. This graphical record obtained in response to the step excitation is …


Scroll to Top