Important Op Amp Parameters

Important Op Amp Parameters:

Two other Important Op Amp Parameters are the slew rate and the power supply rejection ratio (PSRR). Let us discuss and obtain the expressions for these two parameters.

Power Supply Rejection Ratio

Important Op Amp Parameters

The power supply rejection ratio (PSRR) is defined as the ratio of the change in input offset voltage due to the change in supply voltage producing it, keeping other power supply voltage constant. It is also called power supply sensitivity (PSV).

Now if VEE is constant and due to certain change in VCC , there is change in input offset voltage then PSRR is defined as,

Important Op Amp Parameters

For a fixed VCC,  there is a change in VEE, then

Important Op Amp Parameters

As input o set voltage is very small, PSRR is expressed in mV/V or [tV/V. The typical value of PSRR for IC 741 op-amp is 30 µV/V. 2.6.2

Slew Rate

The slew rate is defined as the maximum rate of change of output voltage with time.

The slew rate is specified in V/p. sec. Thus

Important Op Amp Parameters

The slew rate is caused due to limited charging rate of the compensating capacitor and current limiting and saturation of the internal stages of an op-amp, when a high frequency, large amplitude signal is applied. The internal capacitor V voltage cannot change instantaneously. It is given by d  = —I For large charging dt ,  rate, the capacitor should be small or charging current should be large. Hence the slew rate for the op-amp whose maximum internal capacitor charging current is known, can be obtained as

Important Op Amp Parameters

For example, for IC 741 the charging current is 15 IAA and the internal capacitor is 30 pF, hence its slew rate is

Important Op Amp Parameters

Important Op Amp Parameters

The slew rate for noninverting amplifier is worst (smallest) and the circuit used for its measurement is as shown in the Fig. 2.11.

The square wave input is applied to the circuit. The frequency of the applied input is increased till the distorted output is observed on the oscilloscope. It is shown in the Fig. 2.12 (a) and (b).

Then the slew rate is AVo /At.

Important Op Amp Parameters

For example, if the voltage rises from -6 to +6 in 24 gsec then the slew rate is

Important Op Amp Parameters

The typical value of the slew rate for IC 741 Op-amp is 0.5 V iptsec, ideally it should be infinite. Higher the value of slew rate, better is the performance of op-amp. Let us obtain the equation for the slew rate of op-amp.

MORE RELATED ARTICLE

Leave a Reply

Your email address will not be published. Required fields are marked *

COPYRIGHT © 2014 TO 2018 EEEGUIDE.COM ALL RIGHTS RESERVED | HOME | SITEMAP | CONTACT US | ABOUT US | PRIVACY POLICY | Frontier Theme